Home
About Us
News
What is the processing process for stainless steel molds
2023-07-21
1. Material preparation When processing stainless steel molds , it is important to consider the materials required for various products. Basically, the most suitable Mold 2. Rough machining When processing stainless steel molds, the next step is to rough process and select the relevant materials. After that, a washing machine can be used to perform preliminary processing on all the planes and sides. This usually requires the use of various materials, and can be processed through various types of plates. The top and bottom are also different, but the entire cover or other top material plates may also be different. 3. Fine processing When processing these stainless steel molds, it is also necessary to consider the final fine processing, using a grinding machine to process the flat surface, and to process the male clamp plate or other modes. During processing, it is necessary to continuously grind, and even make sure to make a right angle on the entire plane. This will flatten the bottom plate or upper and lower cover plates by grinding the flat surface. 4. Scribe When processing stainless steel molds , it is completely possible to place the processed or ground mold plates on the sliding table, and make relevant drawings based on the existing mold method. Use the height dimensions of the sliding line to comprehensively mark the lines, and then mark and drill the marked mold plates according to the existing situation, ultimately completing the processing. 5. Heat treatment When processing stainless steel molds, the next step is heat treatment. During the heat treatment process, various templates must be effectively processed and quenched continuously through relevant heights or Indian plate processing. Moreover, the entire quenching process must be further processed and the plates must be ground, so that right angles can be made and the cutting line can be processed. 6. Assembly and trial mold When processing stainless steel molds , it is necessary to consider more accessories or supporting guide pillars. The entire set has various different assemblies, allowing for the assembly of more molds. During installation, debugging can also be carried out continuously on the stamping machine tool. Finally, when measuring conflicting areas, it is necessary to consider whether they meet the requirements in order to complete the entire stamping process.
Share to:
