For consumers who buy smart locks for the first time, they may be a little overwhelmed. This lock does not need a key, how to set fingerprints, how to set passwords, how to set faces, etc. A series of questions come to mind, so we It is necessary to give an introduction to the Smart Lock setting method. Although each manufacturer's smart lock is different, the principle is basically the same, so the setting method of the smart lock is basically the same. The general setting method steps are as follows:
The first step, the administrator password setting (the password set for the first time after leaving the factory is the administrator password)
Specific operation method:
1.1. Open the battery cover.
1.2. Press the setting button once and beep once.
1.3. Press the start key (located after the number 3 on the keyboard), enter the password (3-8 digits) and press the # key.
1.4. A beep sounded, the operation was successful.
The second step, open the door card, password, fingerprint lock, remote control settings (the total number is 70, can only be set when there is an administrator password, the remote control is optional)
Specific operation method:
2.1. Open the battery cover
2.2. Press the setting key once
2.3. Press the start button, enter the password (3-8 digits) and press the # button
2.4. Press the start key, enter the number (00-99) and press the # key. 5. Press the start button, enter the door to open the door (3-8 digits), press the # key to end, the password is set successfully; put your finger on the fingerprint window to read the fingerprint, after the beeping sound, press and hold the same finger again to read the fingerprint. If the sound of the two readings is the same, it means that the fingerprint entry is successful; move the card to be set close to the induction area to set the induction card; press any key on the remote control to set the remote control.
The third step, delete the door card, password, fingerprint, remote control
Specific operation method:
3.1. Open the battery cover
3.2. Press the setting key twice in a row
3.3. Press the start button, enter the administrator password, and press the # button
3.4. Press the start button, enter the fingerprint to be deleted, the password, the corresponding number of the remote control, and press the # key. For example, to delete a fingerprint, point your finger at the fingerprint window to read the fingerprint, bring the card to be deleted close to the induction area, and press any key on the remote control.
