Coke bottle
box Mold is generally made of new HDPE materials with high bearing capacity and good toughness. Because of the high output requirements of this mold, the quality and precision of the mold must be high, and the scrap rate must be less than 98% to be a really good plastic Coke box mold.
One key point of the Coca Cola box mold is that the product should not be eccentric. Once eccentric, it is not conducive to the production of the product and the service life of the mold. Therefore, in the design process, there must be a wear-resistant block to adjust the die setting of the Coca Cola box mold. In addition, the core insert on the side of the dynamic mold of the Coca Cola box mold must be locked by the Spike, and it must be calibrated during processing.
After the
Injection Molding of coke box products, most of the products are separated by stripper plates. Therefore, the requirements for polishing the rebar position of the turnover box are very high, and the mold matching at the bottom of the box is also very important. If the rebar position at the bottom is not polished well, it will lead to difficult demoulding. Generally, beryllium bronze insert will be used for the core of turnover box with high requirements, which can increase the effective help for plastic filling and has good cooling effect.
